Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

2924C-XL

Hi Guys,

I have a switch WS-C2924C-XL with IOS (tm) C2900XL Software (C2900XL-H-M), Version 11.2(8)SA4, RELEASE SOFTWARE (fc1) and some questions :

1- When I try to telnet, I received the following message :

"Password is requered, but none set"

I can access the switch via http, How can I set this password ?

2- Yesterday my network almost stop, the access for all machines to the network gone very slow, after I booted the switch everythings gone be OK, how can I do a diagnoses for this switch ?

Thanks,

Alex

2 REPLIES
New Member

Re: 2924C-XL

You will need to get into config and enter a password for the VTY lines

other wise telnet will never work without it.

router(config)# line vty 0 4

router (config-if) # password xxxxxxx enter

xxxxxxxx = password

Do not forget to write mem so command stays otherwise upon

next reload you will have to do these commands again......

New Member

Re: 2924C-XL

1. you need to configure vty lines for password

line vty 0 4

password yourpassword

2. I would suggesthat you the following tech tips for troubleshooting

http://www.cisco.com/warp/public/473/

282
Views
0
Helpful
2
Replies
CreatePlease to create content