05-16-2002 08:34 AM - edited 03-01-2019 09:45 PM
Hi Guys,
I have a switch WS-C2924C-XL with IOS (tm) C2900XL Software (C2900XL-H-M), Version 11.2(8)SA4, RELEASE SOFTWARE (fc1) and some questions :
1- When I try to telnet, I received the following message :
"Password is requered, but none set"
I can access the switch via http, How can I set this password ?
2- Yesterday my network almost stop, the access for all machines to the network gone very slow, after I booted the switch everythings gone be OK, how can I do a diagnoses for this switch ?
Thanks,
Alex
05-16-2002 10:53 AM
You will need to get into config and enter a password for the VTY lines
other wise telnet will never work without it.
router(config)# line vty 0 4
router (config-if) # password xxxxxxx enter
xxxxxxxx = password
Do not forget to write mem so command stays otherwise upon
next reload you will have to do these commands again......
05-16-2002 03:31 PM
1. you need to configure vty lines for password
line vty 0 4
password yourpassword
2. I would suggesthat you the following tech tips for troubleshooting
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide