Cisco Support Community
Community Member

2924M-XL with X2961-XL i want creat an vp with vpi=30


i used this configuration but i want open the vp with VPI=30.

In the consol and in the interface ATM 1. i cannot open the vpi = 30 but i can vpi =0-0 ?

is it possible to do it?

version :

ATM#sh ver

Cisco Internetwork Operating System Software

IOS (tm) C2900 Software (C2900-M-MX), Version 12.0(7)XF, EARLY DEPLOYMENT RELEASE SOFTWARE (fc1)

TAC:Home:SW:IOS:Specials for info

Synced from 12.0(6.5)T4

Copyright (c) 1986-1999 by cisco Systems, Inc.

Compiled Thu 25-Nov-99 23:59 by srsastry

Image text-base: 0x00003000, data-base: 0x00275478

ROM: Bootstrap program is C2900ATM (Pebble) boot loader

ATM uptime is 3 hours, 46 minutes

System returned to ROM by power-on

Running default software

Cisco WS-X2971-XL (PPC403GCX) processor (revision 0) with 8192K/4096K bytes of memory.

1 ATM network interface(s)

64K bytes of non-volatile configuration memory.

Motherboard assembly number: 73-2438-09

Motherboard serial number: FAB062451E8

Model revision number: 01

Motherboard revision number: D0

Model number: WS-X2961-XL

Configuration register is 0xF

configuration :

Current configuration:


version 12.0

no service pad

service timestamps debug uptime

service timestamps log uptime

no service password-encryption max-servers 0 max-servers 0


hostname ATM


process-max-time 198


interface ATM1

atm pvc 1 0 100 aal5snap 1000 1000 32

atm pvc 2 0 101 aal5snap 1000 1000 32

atm pvc 3 0 102 aal5snap 1000 1000 32

atm pvc 4 0 5 qsaal

atm pvc 5 0 16 ilmi

atm multipoint-signalling

atm bind pvc vlan 1 100

atm bind pvc vlan 2 101

atm bind pvc vlan 3 102

no atm ilmi-keepalive


interface ATM1.1 point-to-point


interface ATM1.100 multipoint



line con 0

transport input none

stopbits 1

line aux 0 7



best regards


Re: 2924M-XL with X2961-XL i want creat an vp with vpi=30

Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you. If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center ( or speak with a TAC engineer. You can open a TAC case online at

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.

CreatePlease to create content