Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

2924XL Switch

I just got a 2924XL switch from my corporate headquarters with no IOS installed. I've been trying to load the latest .bin with no success.

I get the switch: prompt and then enter copy xmodem:flash:2900xl.bin 2900.bin

I then get the prompt to start the file transfer and use hyperterminal to do so. After a few seconds hyperterminal says "transfer cancelled by remote system".

When I acknowledge that prompt the switch then says "permission denied"

Any suggestions on what I'm doing wrong?

Thanks

2 REPLIES
Cisco Employee

Re: 2924XL Switch

What is the flow control in the hyperterminal set to? Set flowcontrol to "none" and try

New Member

Re: 2924XL Switch

Thanks for the feedback. HT is configured 9600, 8, N, 1, No Flow control.

Switch still won't accept the .bin file.

183
Views
0
Helpful
2
Replies
CreatePlease to create content