In my office, i have an 2940, no config. I want it to connect to the access sw, which again is connected to the dist/core. My port in the access sw have this config:
switchport access vlan 99
switchport mode access
switchport voice vlan 20
no ip address
When i connect the 2940 to this 0/8 port, only some traffice seems to pass. I have several IP phones in my office, but only two would register. The pc is connected via IP phone, but then, only the pc get's access, not that IP phone. I find this strange, about how i should configure the 0/8 port in the 2940, so that all the traffice from the access sw gets through to all my 2940 ports.
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...