I'm setting up a 2948G-L3 with a single VLAN, and when I move my servers to it the ports recieve alot of error during nightly backups. After searching other message boards I've found most people have the following as the solutions
On the Switch where servers are connected force the port to 100MB/Full Duplex
On the Servers connected to the switch configure the Nic's to 100MB/Full Duplex
Would this be the correct solution for the problem?
Where possible always set the port to match the end device. I set PCs/laptops to auto and have the end users set the same way. But for the important devices, routers/servers/printers/firewalls/switches I always hardcode the port and end device to the highest they can go (eg 100 full).
Don't leave things to chance (ie auto) as errors can and will happen.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.