Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

2948G Layer3 Switch

I am trying to test all the 48 ports to make sure they are working fine. However, I cannot ping successfully. Currently I have a notebook and a Workstation attached to the Switch. All ports have green LEDs. How can I successfully test the ports ?

1 REPLY
Bronze

Re: 2948G Layer3 Switch

every port is the routed port- You have to configure the ip address on every port just like router interface or configure brigding on the switch if you want every port part of same subnet..

Hope these links helps you more

http://www.cisco.com/cgi-bin/Support/browse/psp_view.pl?p=Hardware:Cat2948G-L3&s=Software_Configuration

89
Views
5
Helpful
1
Replies
CreatePlease login to create content