Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

2948g

I just purchased a 2948g layer 2 switch.

Everytime I boot the switch up it stops at the prompt

rommon1>

If I type in boot it will load the switch. Also my passwords I set did not save.

Are you suppose to save any configurations when you make any?

How do I get around that rommon1> prompt problem?

Thank you.

2 REPLIES

Re: 2948g

Seems youe config register is incorrectly set, this needs to be changed.

This should do the trick

rommon1>confreg 0x2102

NB!! you must dump these bits in hex if you forget the 0x then you will be in trouble.

This URL will help:

http://www.cisco.com/univercd/cc/td/doc/product/lan/cat5000/rel_5_5/sw_cfg/boot.htm#29600

Regards

New Member

Re: 2948g

hi,

try this, hope it will work

confreg 0x2

reload

set boot config-register 0x2

set boot system flash bootflash:cat4000.5-5-10.bin

272
Views
0
Helpful
2
Replies
CreatePlease to create content