Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k

2950 cant get through console

Hi

I have a 2950 switch which was not configured,i.e its working in transparent mode.Now I am trying to configure it, but cant get through the console.I have changed the computer as well as the console cable.

Can anyone help me?

2 REPLIES

Re: 2950 cant get through console

Have you tried speed setting 9600 8N1?

Re: 2950 cant get through console

hi

Have u watched out for possible console setting mismatch ?

did u try to reset and check out the booting seq ?

my first suggestion would be to try out the console settings and check out while booting up.

if u get some sucess in that its ok or else just give enough time for the box to boot up and check out changing the console settings again.

Coz u may have the chances of having different baud rate settings on the console port configs.

if possible to get onto the rommon just reset the config to factory defaults so that it will move off the configs if any out there in the console port.

regds

97
Views
0
Helpful
2
Replies
CreatePlease to create content