11-10-2005 01:52 AM - edited 03-03-2019 12:45 AM
Hi
I have a 2950 switch which was not configured,i.e its working in transparent mode.Now I am trying to configure it, but cant get through the console.I have changed the computer as well as the console cable.
Can anyone help me?
11-10-2005 02:09 AM
Have you tried speed setting 9600 8N1?
11-10-2005 02:18 AM
hi
Have u watched out for possible console setting mismatch ?
did u try to reset and check out the booting seq ?
my first suggestion would be to try out the console settings and check out while booting up.
if u get some sucess in that its ok or else just give enough time for the box to boot up and check out changing the console settings again.
Coz u may have the chances of having different baud rate settings on the console port configs.
if possible to get onto the rommon just reset the config to factory defaults so that it will move off the configs if any out there in the console port.
regds
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: