06-19-2006 01:34 PM - edited 03-03-2019 03:43 AM
When I boot up my 2950 switch, it hangs at where the last line of the attachment.
Anyone know if it's a configuration issue, or simply needs replaced?
06-19-2006 01:43 PM
Try to do missing software or corrupted software recovery first.
The procedure is outlined here:
Please rate helpful posts.
06-20-2006 10:39 AM
thanks for the tip.
I was able to force the switch to boot using an IOS in flash, but it still haults during boot, even after I put in a boot system statement.
Will try a different IOS to see if it's image related issue, unless any of you think it's something else.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: