Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

2950 haults during bootup

When I boot up my 2950 switch, it hangs at where the last line of the attachment.

Anyone know if it's a configuration issue, or simply needs replaced?

2 REPLIES

Re: 2950 haults during bootup

Try to do missing software or corrupted software recovery first.

The procedure is outlined here:

http://www.cisco.com/en/US/products/hw/switches/ps628/products_tech_note09186a0080169696.shtml#topic1

Please rate helpful posts.

New Member

Re: 2950 haults during bootup

thanks for the tip.

I was able to force the switch to boot using an IOS in flash, but it still haults during boot, even after I put in a boot system statement.

Will try a different IOS to see if it's image related issue, unless any of you think it's something else.

98
Views
4
Helpful
2
Replies
CreatePlease to create content