Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

2950 LRE and POTS Splitter

HI

Anyone point me to some documentation on how the POTS splitter actually interfaces with a PABX? Not from a telecoms background so am at a loss.

Thanks

3 REPLIES
New Member

Re: 2950 LRE and POTS Splitter

New Member

Re: 2950 LRE and POTS Splitter

Thanks

I have seen that, what I am after is a generic "how to" of breaking the signal fron PABX into POTS splitter.

New Member

Re: 2950 LRE and POTS Splitter

Generally PABX's provides single pair of cable/wires for each POTS telephone connection.

Legend ========= 2 wire

EPABX ======>POTS Device(Phone Handset/CPE/FAX ..etc)

(RJ21 Telco connector will provide 25 such pair of wires.)

Example....For single CPE connection,

Simply take 2 wires coming from EPABX and connect to (1,26)or (2,27) and so on... of RJ 21 connector of Splitter.(Port on Splitter side is PBX A or PBX B)

EPABX=====>(1,26)of RJ21 cable-->PBX port of Splitter

And Take out the corresponding pair of wires

[(1,26) or (2,27)from Splitter other port CPE A or CPE B and exend it to CPE located in remote location.

Splitter CPE port=====>(1,26)of RJ21 cable====>CPE

In short. the diagram look like.

EPABX ===>Splitter Port PBX--Splitter Port CPE===>CPE

Simply the splitter is conncted in series to the

EPABX and POTS device(CPE/Handset)

96
Views
0
Helpful
3
Replies