I implemented port-based security by MAC addresses using VMPS. However, I have huge database of MAC addresses on my RAdius server. Is it possible to configure 2950 to use Radius server to let access to the switch ports according to the PCs' MAC addresses from the RAdius database?
Only documentation I found regarding Radius on 2950 is AAA for logins and accounting info for access to the management of the switch. However, I have not found anything that could stop/allow PCs' to access to the network according to the PCs' MAC address (except VMPS).
Please, if anyone has any ideas, let me know. Thanks,
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...