We have a 2950 swith with the following config. However we are not receiving any connectivity through the switch and all the ports say "no ip address" Can anybody look over the config and let me know if I am missing something.
2950 is a Layer 2 only switch and you cannot assign an IP address. You would see "no ip address" under fastethernet, as this product is similar to 3550 which is a layer 3 switch and shares the same base code. I see all the interfaces in VLAN 10..Make sure you have VLAN 10 in the VLAN database
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.