I have a 2950 switch Ver 12.1.9(EA1) that I am trying to get a set of three servers that are clustered working. The cluster works just fine on the hub currently, but nothing past the hub will find the cluster. I have tried to shut down igmp snooping, add a static arp and mac entry to the tables, but no go.
Eventually, I would like to have the three servers all plugged into the switch, but at this rate I am not going to get there.
The servers are using a multicast MAC address of 0100.5e04.0506 with an IP address of 172.16.101.214.
Do we need to ugrade to a different version of IOS?
Any thoughts/ideas/suggestions would help tremendously!!!!
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...