Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

2950 Switch Web access

When I type the http://ip address in IE to access the switch console in web, after it show the login ID and password, I want to know hwo can find the login ID and password.

1 ACCEPTED SOLUTION

Accepted Solutions
Bronze

Re: 2950 Switch Web access

While the GUI is a helpful tool, it is best to learn the command line for configuring and troubleshooting. From the cli, you can pull more information durring troubleshooting situations. Also, there was a book published not too long ago about "Hacking Cisco Networks". The bulk of the book was spent on exploiting the GUI on cisco devices.

Hope this helps.

5 REPLIES

Re: 2950 Switch Web access

when it prompts for user name & password, you will only need to enter "enable password" or "enable secret" assigned by you when you configure your switch thru console.

hope this helps

rate this post

Re: 2950 Switch Web access

Hi

AFAIK its the username and password configured with privilege level 15..

try configuring a username and password with the above privilege level then it may allow u to get the http level access of your switch.

regds

New Member

Re: 2950 Switch Web access

how to config ,please advise

J

Re: 2950 Switch Web access

Bronze

Re: 2950 Switch Web access

While the GUI is a helpful tool, it is best to learn the command line for configuring and troubleshooting. From the cli, you can pull more information durring troubleshooting situations. Also, there was a book published not too long ago about "Hacking Cisco Networks". The bulk of the book was spent on exploiting the GUI on cisco devices.

Hope this helps.

719
Views
0
Helpful
5
Replies
CreatePlease login to create content