Everytime we entered in our TACACS configuraion the 2950 would reload. The 2950 was reporting the following errors before the TACACS config was entered.
====================================
%UDLD-3-UDLD_IDB_ERROR: UDLD error handling failed to get IDB s
=====================================
We noticed that on the port reporting the error udld was disabled. However, the 6500 it was connected to had udld enabled. Once udld was enabled on the 2950 port that connected to the 6500 we were able to configure the box without any issues. This appears to be a bug in the software. What is the best way to open a bug on this without opening a TAC case?