2950s losing their time and date and other settings
I have several 2950s installed in the last 10 months which I configured with IP address, gateway, DNS, time and date, location and disabling spanning tree. But some of the switches lose their time and date and DNS settings so they've reverted to the defaults when I log back into them some time later. What causes this and how can I fix it?
Re: 2950s losing their time and date and other settings
The uptime is now 3-4 months. No power outages. I saved the running-config to startup-config when I set them up Do I need to restart them after doing that? Also can contact some thru CMS from my office, others I can only contact thru CMS if I'm on site. No difference in setup. Software version is 12.1(13)EA1. Do I need to upgrade.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...