2x ASA 5525X: Active with CX License, Standby without
I have the following situation and I am not getting the information from the Cisco documents I have read:
2x ASA5525-SSD120-K9 should be installed in active/standby mode. The question is if it is possible to buy only one CX license for the active one so that it will be more feature rich than the standby one. If a failover occurs the standby ASA will take over but without the CX features of the old active one.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...