Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

30 Channels Remote Access over PRI in 2621 Router

I have 2621 series Router.I would like to access 30 channel Remote access for PRI interface.What type of Network Infrastructure I need for that Purpose.What type of device need for this one. What are all the configuration I need for that one

Please give me detail about that

thanks in advance

1 REPLY
New Member

Re: 30 Channels Remote Access over PRI in 2621 Router

On the wan side you will need a NM-ICE1B channelized E1/PRI balanced network card in the router.

Not sure how much memory is in a 2621 but recommend a minimum of 64MB dram.

Otherwise this card will give you a full e1 30 cahnnel dial capability ( or less if you only want to run 8 of 30 cahnnels etc )

hope this helps

120
Views
0
Helpful
1
Replies
CreatePlease to create content