we have problem connecting 3550 emi switch with 3500 switch In show logs i am get %RTD-1-LINK_FLAP error in 3500 series switch but i am not get these message in 3550 emi Switch And i have attached the show log of 3500 series switch.
RTD-1-LINK_FLAP [chars] link down/up [dec] times per min
Explanation This message indicates that an excessive number of link down-up events has been noticed on this interface: [chars] is the interface, and [dec] is the number of times the link goes up and down. This might be the result of reconfiguring the port, or it might indicate a faulty device at the other end of the connection.
Action If someone is reconfiguring the interface or device at the other side of the interface, ignore this message. However, if no one is manipulating the interface or device at the other end of the interface, it is likely that the Ethernet transceiver at one end of the link is faulty and should be replaced.
But what is the soluation for these problem the link is going down very offen and it is not communacting to other switch
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...