Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

3524XL logs

I saw the following in the log of the switch today:

wer

Dec 18 11:24:37: %PM-3-POWER_INLINE_BAD: FastEthernet0/21 is drawing too much po

wer

Dec 18 11:25:38: %PM-3-POWER_INLINE_BAD: FastEthernet0/21 is drawing too much po

wer

Dec 18 11:26:40: %PM-3-POWER_INLINE_BAD: FastEthernet0/21 is drawing too much po

wer

Dec 18 11:27:41: %PM-3-POWER_INLINE_BAD: FastEthernet0/21 is drawing too much po

wer

Dec 18 11:28:42: %PM-3-POWER_INLINE_BAD: FastEthernet0/21 is drawing too much po

wer

Dec 18 11:29:43: %PM-3-POWER_INLINE_BAD: FastEthernet0/21 is drawing too much po

wer

Dec 18 11:30:26: %LINK-3-UPDOWN: Interface FastEthernet0/21, changed state to up

Dec 18 11:30:27: %LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/2

1, changed state to up

rwc-sw-idf4-1-9#

rwc-sw-idf4-1-9#

rwc-sw-idf4-1-9#

rwc-sw-idf4-1-9#sh int faas

rwc-sw-idf4-1-9#sh int fast

rwc-sw-idf4-1-9#sh int fastEthernet 0/21

FastEthernet0/21 is up, line protocol is up

Hardware is Fast Ethernet, address is 0002.7d7d.4655 (bia 0002.7d7d.4655)

MTU 1500 bytes, BW 100000 Kbit, DLY 100 usec,

reliability 255/255, txload 1/255, rxload 1/255

Encapsulation ARPA, loopback not set

Keepalive not set

Auto-duplex (Full), Auto Speed (100), 100BaseTX/FX

ARP type: ARPA, ARP Timeout 04:00:00

Last input 00:00:42, output 00:00:00, output hang never

Last clearing of "show interface" counters never

Queueing strategy: fifo

Output queue 0/40, 0 drops; input queue 0/75, 0 drops

5 minute input rate 0 bits/sec, 0 packets/sec

5 minute output rate 60000 bits/sec, 59 packets/sec

4916596 packets input, 3771046873 bytes

Received 64646 broadcasts, 0 runts, 0 giants, 0 throttles

0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored

0 watchdog, 58895 multicast

0 input packets with dribble condition detected

219260979 packets output, 2399126954 bytes, 0 underruns

0 output errors, 0 collisions, 1 interface resets

0 babbles, 0 late collision, 0 deferred

0 lost carrier, 0 no carrier

0 output buffer failures, 0 output buffers swapped out

rwc-sw-idf4-1-9#

What can could be the issue ?

Thanks,

1 REPLY
New Member

Re: 3524XL logs

You have probably already checked on CCO and found that there is no explaination for this error at this time. So my guess is that you have a full or partial short on pins 4&5,7&8 as these provide power for an IP phone or you have a faulty NIC connected to this port. I suggest that you check the connected device and the cabling.

79
Views
0
Helpful
1
Replies
CreatePlease to create content