Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

3548 Gigabit Stack

I have two 3548XL switches in a stack using a GBIC connector. The response time from the member stack seems significantly higher than the response time from the controller. I have changed the duplex to half, which has helped somewhat. Is there any other configurations that I should check?

  • Other Network Infrastructure Subjects
3 REPLIES
New Member

Re: 3548 Gigabit Stack

Do you have the following config on your Gig interfaces.

interface GigabitEthernet0/1

duplex half

switchport mode trunk

When stacking just 2 3548 you can run full duplex.

If you are pinging the second contorller switches uslly have a high ping respone, but if you ping a work station the ping will be fine.

You also need to have enterprise software.

New Member

Re: 3548 Gigabit Stack

I'm runnning Version 12.0(5)XU, which came with the switch. I think that it is enterprise software.

That is the configuration that I currently have. I also have the lines:

switchport trunk encapsulation dot1q

switchport trunk allowed vlan 1-10,1002-1005

New Member

Re: 3548 Gigabit Stack

Since you are allowing all of the default VLANs try replacing

switchport trunk allowed vlan 1-10,1002-1005

with

switchport mode trunk

This may speed things up telling the switch to pass all VLANs insteading having the switch decide which ones

151
Views
0
Helpful
3
Replies
This widget could not be displayed.