Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

3548 switch flash loading problem

i want to load flash file into 3548 switch and the 3548 is in following state:

how do i proceed with it.

switch: ?

? -- Present list of available commands

boot -- Load and boot an executable image

cat -- Concatenate (type) file(s)

copy -- Copy a file

delete -- Delete file(s)

dir -- List files in directories

flash_init -- Initialize flash filesystem(s)

format -- Format a filesystem

fsck -- Check filesystem consistency

help -- Present list of available commands

load_helper -- Load and initialize a helper image

memory -- Present memory heap utilization information

mkdir -- Create dir(s)

more -- Concatenate (display) file(s)

rename -- Rename a file

reset -- Reset the system

rmdir -- Delete empty dir(s)

set -- Set or display environment variables

set_param -- Set system parameters in flash

sleep -- Sleep a specified number of seconds

trap -- Cause a software breakpoint to occur

type -- Concatenate (type) file(s)

unset -- Unset one or more environment variables

version -- Display boot loader version

switch:

awating reply soon.

thanks

1 REPLY
Bronze

Re: 3548 switch flash loading problem

You can use the copy command to load a file onto flash. For example:

Switch# copy tftp://10.200.8.200/config.text flash:config2.text

Here is a link that explains this in more detail:

http://www.cisco.com/warp/public/473/10.html#2

262
Views
0
Helpful
1
Replies
CreatePlease to create content