What could be a possible reason why in a three switch setup-all attached to one router(a 3640) would the first switch pass outgoing traffic better(faster) than the other two. All are set up the same, using the gig uplinks, same default gateway(the router) and default settings? ie on a streaming video coming in to the office the first encodes at 245kb while on the other two it's at 22k ? Clearly there is some type of bottleneck here-any ideas??
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...