If I set up a link from a 3548 to a GEIP+ and segment the switch into 3 vlans, what IP should I use on the switch for the default gateway?
Also, do I have to set up a native vlan for vlan 1 since it is DOT1Q? I have only used the ISL trunks before and was not sure of the config. I am trying to set the switch up to pass 4 vlans over the Gig port to the router. The 3548 is set based.
There wont be an ip on the switch used for default gateway, which is the job of the router. A layer 2 switch doesnt care about layer 3 addressing at all. Your router will have four subinterfaces , these will be the default gateways one for each of the respective networks. http://www.cisco.com/warp/public/473/50.shtml
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...