Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

3550 12g Console Port just outputs ascii characters when used

When I use the console port I will sometimes get normal characters but most of the time it just oupts junks. The console port is default speed at 9600 and terminal session is set right. I have 40 switches and this is the only one giving me an issues. I upgraded to the lastest code and still has the same problem. If I telnet to the switch it works fine. Does anyone have any ideas. I tried changing the speeds on the console port and it didn't help. I am out of ideas with this problem.

Thanks,

John

1 REPLY
New Member

Re: 3550 12g Console Port just outputs ascii characters when use

Definately give TAC a call, it has been a while but I have seen similar problems on a 3745 router and ended up having the entire motherboard replaced.

253
Views
0
Helpful
1
Replies
CreatePlease to create content