I am new to the 3550 and to L3 routing on the switch. I need to create 3 vlans(no problem) with no routing between the vlans, then route all the Internet traffic from each vlan out one port to a PIX. The PIX config is no problem.
vlan101 \ ----> PIX------>2600----->Internet
I have not been able to find many configuration examples for L3 routing on the 3550's.
Can someone please point me to where I can find resources, examples and sample configs, using the 3550 and L3 routing.
You also have to installe an ios which supports the routing. On the linked page you will find it right on top.
I would just make the port to the pix a L3 port with the command "no switchport". After that you can define a IP Address for the port. And finaly you have to configure a static route which points to the pix "ip route 0.0.0.0 0.0.0.0 ".
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.