Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

3620 dialin bundle

Folks,

Here is the situation, not sure if it would work.

I have a 3640 connected to a PRI using 2MFT1 card sitting inside a HDV module. One port connectes to the PRI and the other port is connected back-to-back

to a controller port on a 3620 which is housing the digital modem bank.

-------Pri---------3540--back-to-back-t1-----3520

What i want to do is route the moden calls (based on DIDs) to the 3620 and route voice calls to the call manager at the 3640 router.

Everything seems to be working fine, EXCEPT

I am not able to dial out using the digital modem bank ( we have to dial out once in a while to other unix boxes). When i try to dialout (reverse telnet) ATDT command, debug shows no carrier.

But i can dialin through the pri and the modems in the digital modem banks respond and negociate.

when i dial outside, debug also shows me that the call goes from 3620 to 3640 and then to the PRI, but for some reason i get no carrier error.

any ideas?

also do i need "incoming-call modem" command

Thanks

1 REPLY
VIP Purple

Re: 3620 dialin bundle

Hello,

hard to say. I think you need something like the modem inout command. Can you post both configs of the routers ?

Regards,

GP

92
Views
0
Helpful
1
Replies