Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

3640 Configuration

I have a 3640 Router with t1/e1 module and 2 fast ethernet modules. I want to prioritize the traffice to/from the different ethernet/fastethernet modules through the serial interface. FE 1/0 highest priority, FE 2/0 Medium, and E 0/0 lowest. Any suggestions welcome.

Thanks

1 REPLY
New Member

Re: 3640 Configuration

You can use policy routing on the three interfaces to set the IP Precedence of the incoming packets and then use some of the QoS mechnisms using IP Precedence.

Hope this helps.

Lora

87
Views
0
Helpful
1
Replies
CreatePlease to create content