Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
240
Views
0
Helpful
1
Replies

3640 Configuration

krsschool
Level 1
Level 1

‎06-24-2003 08:04 AM - edited ‎03-02-2019 08:23 AM

I have a 3640 Router with t1/e1 module and 2 fast ethernet modules. I want to prioritize the traffice to/from the different ethernet/fastethernet modules through the serial interface. FE 1/0 highest priority, FE 2/0 Medium, and E 0/0 lowest. Any suggestions welcome.

Thanks

Labels:
0 Helpful
1 Reply 1

loralubo1
Level 1
Level 1

‎06-24-2003 12:15 PM

You can use policy routing on the three interfaces to set the IP Precedence of the incoming packets and then use some of the QoS mechnisms using IP Precedence.

Hope this helps.

Lora

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents