Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

3640 router Error

Greetings,

I am getting following errors on my 3640 routers. I don't know what it means?

GMT: %AMDP2-FE-6-EXESSCOLL:Ethernet0/0 TDR0 TRC=0

I am getting some input and output errors on e0/0 interface.

  • Other Network Infrastructure Subjects
1 ACCEPTED SOLUTION

Accepted Solutions
Bronze

Re: 3640 router Error

half duplex ethernet gets collisions as a part of how it works; csma/CD. When there are a lot of collisions it affects performance. This message is telling you that the router is seeing an excessive number of collisions on that interface.

It can be caused by valid increased load. It usually happens at some bottleneck in the net. It can also happen when a host screws up and causes a data storm (unicast) or broadcast storm. You need to profile the data on the link using a sniffer or some such tool.

1 REPLY
Bronze

Re: 3640 router Error

half duplex ethernet gets collisions as a part of how it works; csma/CD. When there are a lot of collisions it affects performance. This message is telling you that the router is seeing an excessive number of collisions on that interface.

It can be caused by valid increased load. It usually happens at some bottleneck in the net. It can also happen when a host screws up and causes a data storm (unicast) or broadcast storm. You need to profile the data on the link using a sniffer or some such tool.

88
Views
0
Helpful
1
Replies
This widget could not be displayed.