Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

3640 udp ports

I have a 3640 with 3 WAN sites and 20 remote users using a default address pool from router. I can not get my logon scripts, anti-vitus or wins to work on the WAN and dial-ups. I believe this is due to all these protocols using UDP ports which are, by default, disabled.

Can someone please tell me how to enable the UDP on my WANs and dial ups "without" giving the world and his dog access into my network?

I have enabled it on 1 port to allow me to use remote control software but can not seem to be able to allow on more than 1 unless I just enable them all. My concern is allowing illegal access to my network.

Any help would be greatly appreciated

1 REPLY
New Member

Re: 3640 udp ports

86
Views
0
Helpful
1
Replies
CreatePlease to create content