Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

3640 use e1,when ping sometimes loss packet 10-20%.

show controllers e1,display line code Violations is very high to 21780,check e1 line coding all is hdb3.

why cause it?

1 REPLY
New Member

Re: 3640 use e1,when ping sometimes loss packet 10-20%.

I am not very familiar with coding schemes other than B8ZS and AMI but it is all for the same purpose (ones density). Do I understand correctly that you verifed that all equipment (including your carrier) is configured for a common coding scheme? Usually a very high number of violations simply means a misconfiguration somewhere in the circuit path. If there are other error in addtion to the code violations, it is probably just a run-of-the-mill circuit problem.

89
Views
0
Helpful
1
Replies