Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

3745 Can't See NM-1T3/E3 NetMods

I have a new 3745 with two (2) single port NM-1T3/E3 netmods. The router does not see either of them. I've tried each one separately in each slot - no lights at all. No serial ports show in the config.

The router has an AIM-VPN/HPII mod installed.

3 REPLIES

Re: 3745 Can't See NM-1T3/E3 NetMods

You might not be having the right IOS software that supports the NM.

12.2(8)T1, 12.2(11)YT, 12.2(15)ZJ, 12.3(1) any of the above supports the module.

Hope that helps

New Member

Re: 3745 Can't See NM-1T3/E3 NetMods

The router will not recognize it initially. You have to tell the router that it exists.

The following link tells how to properly configure it.

http://www.cisco.com/en/US/products/sw/iosswrel/ps5012/products_feature_guide09186a0080108fab.html#1179635

bcbv

New Member

Re: 3745 Can't See NM-1T3/E3 NetMods

You're the man. The issue was finding an IOS that supports both the AIM VPN/HPII mod (IP Plus IPSec 3DES) and the T3 mods. 12.3.1a LD did it.

Thanks

99
Views
5
Helpful
3
Replies
CreatePlease to create content