I have a 3750-48TS(main) and a 3750-24TS(secondary) and when the 24TS switch boots up it elects itself as the master, even though my 3750-48TS has already been elected as master. I set the 48PortSW to highest priority.
I can see ports all the ports on main switch, but the stack member switch cannot reconize the master switch(48port). Any suggestions?
What problem does it imply exactly? The whole configuration is supposed to be driven from the master. In fact, L3 control protocols are centralized on the master. Only the L2 protocols run distributed, and those only need to see the local ports.
Yesterday, I reloaded the master switch on off production hours, everything works. When I originally posted, was trying to accomplish this without rebooting the switch. I learned that this was a simple fix. Thanks for your reply though.
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...