I am new to the networking world and have some questions.
I have 1 stack of six 3750 switches with a 10.50.3.10 ip address
On the first stack (.10)I have int 6/0/19 , 20 and 21 assigned.
I have a second ip scheme with one switch with an ip of 10.50.3.11
Do I use a smartwise cable to connect the switches even though they have different ip schemes? Or do I use a only a cat 5 to connect the 2 differenet stacks. Also, do I need to configure the 6/0/19, 20 and 21 ports on the second ip scheme. I don't think it is possible now that I am writing this if the smartwise cables are not used. Any help would be appreciated.
I apologize but I am not following you entirely. If you stack the 3750, you must use the stacking port and use the stackwise cable.
You said: I have 1 stack of six 3750 switches with a 10.50.3.10 ip address
>> This would mean you stacked them using the stackwise cable and all these six switches are seen as one single device.
What do you mean by you have int 6/0/19-21 assigned? Assigned them what?
You said: I have a second ip scheme with one switch with an ip of 10.50.3.11
>> Sounds like you have another stack? Because the device will complaint if you address two different interfaces in teh same switch/router to the same subnet (10.50.3.10 and 10.50.3.11), unless these addresses are masked as host but I doubt that.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...