Theses switches come with "StackWise" cables that plug in the back of the switches. They are pretty chunky cables.
Once they are linked together via these cables, then they will instantly see eachother. You can check this out with the "show switch" command and it will tell you what is in the stack.
The think to be aware of is the numbring of the stacks - switch 1, switch 2, etc. This is important as there is only 1 config between them. You can press the button on the front of the switch to find out switch numbers. In config modes, you can set the switch numbers of the stack with the command "switch 1 renumber 2" etc.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...