I have 2 3750x switches in a stack. Both running version c3750e-universalk9-mz.152-1.E1. If I use the command sh hw-module I can see all 4 ports of the modules. (2 on switch 1 and 2 on switch 2). I can't get a link light on the module on switch 1. If I move the cables down to the ports on switch 2 they link up correctly. Is there something I can do to test the module itself to determine if the module is bad? All 4 ports are setup the same. Trunk ports connected to 2 UCS servers. Any help would be greatly appreciated.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.