Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

3920 and VTP how can I configure it?

I have some 3920's in place which I would like to create a VTP domain for. I am not using the stack cables but instead have set ports 23-24 as tokenchannel. I can't figure out how I get the VTP info from the switch I have configured for server to the one I have configured for client. Can this be done via tokenchannel? If so how?

1 REPLY
VIP Purple

Re: 3920 and VTP how can I configure it?

Hello,

I could be totally off here, but I think VTP information is not carried across a TokenChannel. VLAN port assigment is done manually, as described in the following document:

Connecting two Catalyst 3900s via TokenChannel

http://www.cisco.com/univercd/cc/td/doc/product/lan/trsrb/scen3.htm

Regards,

GP

92
Views
0
Helpful
1
Replies
CreatePlease to create content