3Com PRO TA on WIC-2A/S

[akostovski]

Hi,

I have a terible problem. I use 3Com PRO TA connected on c1721 + WIC-2A/S as dial-in server and 3Com PRO TA as dial-in modem, too.

I get the folowing log:

1d02h: TTY1: DSR came up

1d02h: tty1: Modem: IDLE->(unknown)

1d02h: TTY1: EXEC creation

1d02h: TTY1: set timer type 10, 30 seconds

1d02h: TTY1: Autoselect(2) sample 7E

1d02h: TTY1: Autoselect(2) sample 7EFF

1d02h: TTY1: Autoselect(2) sample 7EFF7D

1d02h: TTY1: Autoselect(2) sample 7EFF7D23

1d02h: TTY1 Autoselect cmd: ppp negotiate

1d02h: TTY1: EXEC creation

1d02h: TTY1: create timer type 1, 600 seconds

1d02h: TTY1: destroy timer type 1

1d02h: TTY1: no timer type 0 to destroy

1d02h: TTY1: no timer type 2 to destroy

1d02h: TTY4: autoconfigure probe started

1d02h: %LINK-3-UPDOWN: Interface Serial0, changed state to up

1d02h: TTY1: Async Int reset: Dropping DTR

1d02h: TTY1: DSR was dropped

1d02h: tty1: Modem: READY->(unknown)

1d02h: TTY1: dropping DTR, hanging up

1d02h: tty1: Modem: HANGUP->(unknown)

1d02h: %LINK-5-CHANGED: Interface Serial0, changed state to reset

Does anyone know why it start disconnect yust before LCP ???

Does anyone has a similar configuration ???

THANKS

[tepatel · Accepted solution]

We need to see the config as it looks like the router is configured for EXEC connection..not PPP. So post the config here.

[akostovski]

Hi ,

I have solved the problem. Some locking speed problem between modems and "exec" comand in serial interface

Thanks for answering