Everything after 'Assuming 10.1.1.x addresses: ' in my original post is part of the example from my ISP. Thus, their idea of how to set up a private 10.x.x.x net. My private net is currently 192.168.x.x, however.
Current setup is that the 677 is at 192.168.1.1, the server is at 192.168.1.2., NAT is on. This is the default config for a single outside IP, which is something like 2126.96.36.199.
Now, I have been given an additional 4 IP block at something like 2188.8.131.52 thru 2184.108.40.206 externally speaking. The 'free' IP, the one not preassigned to the network, router, or broadcast should be directed to the same server, ideally at a different private IP. Thus, I want to have two 287.65.x.x IPs on the WAN be routed one-to-one to two 192.168.x.x IPs on the LAN.
You can also use the same without static port mapping.
I don't see what that means in this situation. I have multiple inside machines, but only one is reachable from the outside normally. Does this count as one machine, as far as the manual is concerned?
As far as I can see from the manual, each port has to be specified as well as the protocol. I'd like to have all incoming on the new external IP go to the new internal IP. This would avoid having to update the router entries with each new service.
If I can't do that, then can I just leave the present configuration and add the following for the new external IP?
set nat entry add 192.168.1.3 80 2220.127.116.11 80 tcp
set nat entry add 192.168.1.2 8080 218.104.22.168 80 tcp
Thus, doing port forwarding for tcp, since 192.168.1.2 is the current default internal IP. Would this continue to let everything thru on the old IP?
I still haven't been able to get this to work. It appears I need an external interface for the second IP. That is, I need to increase the max number of virtual circuits (from 1 to 2) and then use the Set Interface command to assign the new global IP to wan0-1. Can someone confirm this?
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.