Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

4000 SupIII, how do I config it so I will receive a message if an interface

goes down. Say I telnet/console into the 4000.

TIA

1 REPLY
Cisco Employee

Re: 4000 SupIII, how do I config it so I will receive a message

Enable "logging event link-status" under the interface in question

interface FastEthernet3/3

logging event link-status

You can use the interface range command if you wish to enable this for all the interfaces

261
Views
0
Helpful
1
Replies
CreatePlease to create content