greetings
we have a core of 2 catalyst 4006 switch's and we were experiencing some network anomalies, so we decided to reboot the equipments, one of them does not boot up properly in the post the supervisor modules gives this errors:
Power-on-self-test for Module 1: WS-X4013
Status: (. = Pass, F = Fail)
uplink port 1: . uplink port 2: . eobc port: .
processor: . cpu sdram: . rtc: .
eprom: . nvram: . flash: .
temperature sensor: . enet console port: . switch 0 port 0: .
switch 0 port 1: . switch 0 port 2: . switch 0 port 3: .
switch 0 port 4: . switch 0 port 5: . switch 0 port 6: .
switch 0 port 7: . switch 0 port 8: . switch 0 port 9: .
switch 0 port 10: . switch 0 port 11: . switch 0 registers: .
switch 0 sram: . switch 1 port 0: . switch 1 port 1: .
switch 1 port 2: . switch 1 port 3: . switch 1 port 4: .
switch 1 port 5: . switch 1 port 6: . switch 1 port 7: .
switch 1 port 8: . switch 1 port 9: . switch 1 port 10: .
switch 1 port 11: . switch 1 registers: . switch 1 sram: .
switch 2 port 0: . switch 2 port 1: . switch 2 port 2: .
switch 2 port 3: . switch 2 port 4: . switch 2 port 5: .
switch 2 port 6: . switch 2 port 7: . switch 2 port 8: .
switch 2 port 9: F switch 2 port 10: . switch 2 port 11: .
switch 2 registers: . switch 2 sram: F
Module 1 Failed
does anyone know if these problems are only solved by replacing the hardware ?!