Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

4003 does not boot up properly

greetings

we have a core of 2 catalyst 4006 switch's and we were experiencing some network anomalies, so we decided to reboot the equipments, one of them does not boot up properly in the post the supervisor modules gives this errors:

Power-on-self-test for Module 1: WS-X4013

Status: (. = Pass, F = Fail)

uplink port 1: . uplink port 2: . eobc port: .

processor: . cpu sdram: . rtc: .

eprom: . nvram: . flash: .

temperature sensor: . enet console port: . switch 0 port 0: .

switch 0 port 1: . switch 0 port 2: . switch 0 port 3: .

switch 0 port 4: . switch 0 port 5: . switch 0 port 6: .

switch 0 port 7: . switch 0 port 8: . switch 0 port 9: .

switch 0 port 10: . switch 0 port 11: . switch 0 registers: .

switch 0 sram: . switch 1 port 0: . switch 1 port 1: .

switch 1 port 2: . switch 1 port 3: . switch 1 port 4: .

switch 1 port 5: . switch 1 port 6: . switch 1 port 7: .

switch 1 port 8: . switch 1 port 9: . switch 1 port 10: .

switch 1 port 11: . switch 1 registers: . switch 1 sram: .

switch 2 port 0: . switch 2 port 1: . switch 2 port 2: .

switch 2 port 3: . switch 2 port 4: . switch 2 port 5: .

switch 2 port 6: . switch 2 port 7: . switch 2 port 8: .

switch 2 port 9: F switch 2 port 10: . switch 2 port 11: .

switch 2 registers: . switch 2 sram: F

Module 1 Failed

does anyone know if these problems are only solved by replacing the hardware ?!

1 REPLY
Bronze

Re: 4003 does not boot up properly

this is the hardware failure- Open up the tac case to RMA

79
Views
0
Helpful
1
Replies
CreatePlease to create content