Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

4006 and 4232 L3 Card with SNMP

I have an 4232 L3 card in an 4006 Catalyst. I route 15 VLAN with the L3 switching Card. I search to known if I can show through SNMP the in and out packet on each Port Channel on the 4232 card. If I search with an SNMP browser, I don't found the Port Channel in the IfIndex. Does it exist an special MIB to interrogate the Port Channel information on the 4232 Card.

thanks for your help.

1 REPLY

Re: 4006 and 4232 L3 Card with SNMP

Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you. If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center (http://www.cisco.com/tac) or speak with a TAC engineer. You can open a TAC case online at http://www.cisco.com/tac/caseopen

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.

97
Views
0
Helpful
1
Replies
CreatePlease to create content