Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

4006 and Inline blades

We just got a inline power 48 port 10/100. We will use to power our wireless 1200 AP's. Can we just plug this inline blade in our 4006 ( has 3 400watts power supply) or do we need other modules.

1 ACCEPTED SOLUTION

Accepted Solutions
New Member

Re: 4006 and Inline blades

If you're going to do this in the 4006, you will also need an external power shelf and a power entry module. However, if you were to upgrade the chassis and power supplies to the 4500, you can do it without all the extra gear, and still use all your current modules from the 4006.

1 REPLY
New Member

Re: 4006 and Inline blades

If you're going to do this in the 4006, you will also need an external power shelf and a power entry module. However, if you were to upgrade the chassis and power supplies to the 4500, you can do it without all the extra gear, and still use all your current modules from the 4006.

75
Views
0
Helpful
1
Replies