Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

4006 CAT OS Command help

I have got a 4006 Supervisor Engine 2 and a Gigabit module - WS-X4148-RJ45V 48 port 10/100/1000Base-T Gigabit Ethernet and another 10/100 module - WS-X4448-GB-RJ45 48 port inline 10/100Base-TX ports

Since its is using CAT OS and Im not familiar with CAT OS, I would really like some help on CAT OS command to do the following:

1. Set-up the switch just to do normal switching - no fancy stuff like, VLAN etc

2. Set up the GIG/10/100 ports to be on Etherchannel

Hope someone helps

1 REPLY
Bronze

Re: 4006 CAT OS Command help

Hi,

Start out by reading the catalyst 4000 quick start guide.

http://www.cisco.com/univercd/cc/td/doc/product/lan/cat4000/rel7_1/quick_sw/index.htm

80
Views
0
Helpful
1
Replies
CreatePlease to create content