4006 Gig Ethernet, 1000SX mod, Sup III implementation

[pjmiller]

We are in the preparation phase, getting ready to implement a new Catalyst 4006 CORE Switch, with 1 - WS-X4448-GB-RJ45 module, 1 - WS-4148-RJ module, 2 - WS-X4306-GB modules and a Supervisor III Module.

I would like to find some GOOD references for implementation and IOS configuration, but have yet to locate anything worthwhile.

Does anyone know of some good Technical references for the 4006??

TIA

Pete

[Bradley Littlejohn]

Everything you need is on this doc.

http://www.cisco.com/warp/public/473/103.html

You will need to convert the CatOS commands to IOS. We don't have the doc out yet for IOS but it will be the same just with IOS commands.

[pjmiller]

Thank you very much!

I only wish I had more TIME to keep up with technology. My current position is becoming more of a "firefighter" position, chasing down network ghosts, with nothing more than a Fluke One-Touch...:(

Again, thanks!

Regards,

Pete Miller